PT - JOURNAL ARTICLE AU - C Gruenauer-Kloevekorn AU - U Kloevekorn-Fischer AU - G I W Duncker TI - Contact lenses and special back surface design after penetrating keratoplasty to improve contact lens fit and visual outcome AID - 10.1136/bjo.2005.069500 DP - 2005 Dec 01 TA - British Journal of Ophthalmology PG - 1601--1608 VI - 89 IP - 12 4099 - http://bjo.bmj.com/content/89/12/1601.short 4100 - http://bjo.bmj.com/content/89/12/1601.full SO - Br J Ophthalmol2005 Dec 01; 89 AB - Aims: To describe the fitting of patients with high or irregular astigmatism following penetrating keratoplasty with contact lenses and to answer the question whether or not contact lenses with special back surface design can improve visual acuity in complex cases after penetrating keratoplasty. Methods: 28 eyes were included. They were fitted with contact lenses with a special back surface that was designed for optical rehabilitation after penetrating keratoplasty. Four different types of these lenses (tricurve, keratoconus, reverse, oblong) were used selectively depending on abnormal eccentricity determined by videokeratoscope. The patients were followed up for an average period of 15.5 months. Lens tolerance and corrected visual acuity were evaluated and compared with that corrected with spectacles. Results: The visual acuity was significantly improved in nearly all eyes with an average increase of 3.6 lines (maximal nine lines) accompanied by good contact lens tolerance and satisfactory contact lens fit. No noticeable complications were observed. Conclusion: Contact lenses with special back surface design can improve visual results and lens tolerance, and minimise problems in contact lens fitting. This is in favour of contact lenses as an alternative to surgical procedures for correction of high or irregular astigmatism after penetrating keratoplasty. This procedure is recommended especially in cases of patients who decline further operative interventions.